SIVACON is a tested low pressure switchboard system
And the standard is a combination of electrical panels and control equipment that is used to provide electrical infrastructure in industries (administrative and functional buildings, industrial and commercial buildings) as well as in process industries.
SIVACON is designed to meet the needs of the global market: in such a way that it meets the standard requirements from a single source as well as the need for local production. This system can be used in all applications up to a current of 7400 amperes. including:
as the main electrical panel (power control center or main distribution panel)
as motor control board (MCC)
As a sub-distribution board
Due to SIVACON's modular design, this system can be combined in different types and can meet a wide range of needs in both fixed and sliding designs.
Weak pressure panels are designed and produced according to the needs of the project and the specifications included in the drawings, technical documents and the way of operation and environmental conditions (average temperature, relative humidity, IP protection degree, etc.) in fixed and sliding types with galvanized and oiled sheets. Weak pressure panels of Sivakan design for huge infrastructure and industrial projects are produced in two SPT and S8 designs in the form of bolt and nut cells with galvanized frames, for all input and output feeders and electrical consumers in the following types:
- Power panels (Power Center)
- Main Distribution Board
- Motor Control Center panels (MCC-Motor Control Center)
- Sub distribution boards
The position of the main busbar (top or bottom) and the way to access the panel (front or back) can be selected based on the needs of the project and the limitations of the installation site.
The sliding feeders of these panels have the ability to install all kinds of compact air and automatic switches, three-bridge and four-bridge and have three modes (Connect, Disconnect & Test Position) connect, disconnect and test.
According to the type and specifications of panel feeders, it is possible to use cells with the titles FC1B1, FCB2, FCBCSOFW, etc.
